| Fault Code Description |
|---|
|
Diagnosis monitors oxygen-sensor control. The fault is detected when the fuel/air mixture of cylinder bank 1 is too lean and the adaptation limit (30 %) is exceeded for 50 s. Possible cause of fault: - Intake manifold pressure sensor before and after throttle valve defective - Leak in exhaust system - Catalytic converter clogged - Fuel injector defective |
| Fault Code Conditions | |
|---|---|
| General Conditions |
Voltage condition: - System voltage > 10 V Temperature condition: - Ambient temperature > -10 °C Time condition: - None Other conditions: - Engine on |
| Terminal Condition |
|
| Driving Conditions |
|
| Fault Time Condition |
|---|
|
The fault code is entered when a time interval cannot be specified while certain conditions are met. |
| Service Plan |
|---|
|
- Visual inspection of affected components - Locate leaks and rectify - Replace pressure sensors in intake system - Check plug contacts and electrical lines of pressure sensors in intake system - Catalytic converter for one cylinder bank burnt out (visually inspect through probe supports) |
| Fault Impact |
|---|
|
Possible noticeable symptoms: - Engine running - rough (misfiring, - rough idling) Breakdown information: - None |
| Warnings | |
|---|---|
| Warning Lights |
- Emission warning lamp ECE: ON - Emission warning lamp US: ON - Electronic engine output reduction ECE: OFF - Electronic engine output reduction US: OFF - CC-message: NONE |
| Control Center Messages |
|
| Service Notes |
|---|
|
- None |