| Fault Code Description |
|---|
|
The diagnosis monitors communication between the engine control unit and the gear sensor. Fault monitoring conditions: The fault is detected when there is a fault in the checksum of the messages sent. |
| Fault Code Conditions | |
|---|---|
| General Conditions |
Temperature precondition: - None Time precondition: - None Other preconditions: - None Control unit voltage: 9 V to 16 V. |
| Terminal Condition |
Terminal 15 on |
| Terminal Condition |
PWF status: Driving |
| Terminal Condition |
PWF status: Testing-analysis-diagnosis |
| Driving Conditions |
Note: The designations of terminal status or PWF status apply according to the vehicle electrical system of the vehicle. |
| Fault Time Condition |
|---|
|
The fault is entered within 10 seconds. |
| Service Plan |
|---|
|
Check lines and plug connections between the following components: - Gear sensor. - Engine control unit. Check gear sensor with diagnosis system. - Replace gear sensor. |
| Fault Impact |
|---|
|
- Automatic engine start-stop function deactivated. - Reverse gear recognition not functioning. - Driving stabilisation deactivated (Check Control message). - Tyre pressure control deactivated. |
| Warnings | |
|---|---|
| Warning Lights |
None |
| Control Center Messages | |
| Service Notes |
|---|
|
- None. |