Fault Code Description |
---|
The fault code entry tells the monitoring if the aerial has an internal fault (e.g. internal short circuit), a short circuit or a line disconnection. Fault code entry condition: The aerial self-test found the aerial to be faulty or it is maximumly out of tune. Resetting condition: The aerial was successfully used. |
Fault Code Conditions | |
---|---|
General Conditions |
Control unit voltage: 9 V - 16 V; no undervoltage |
Terminal Condition |
Terminal 30 on |
Terminal Condition |
PWF status: Driving |
Terminal Condition |
PWF status: Testing-analysis-diagnosis |
Terminal Condition |
PWF status: Residing |
Driving Conditions |
Note: The designations of terminal status or PWF status apply according to the vehicle electrical system of the vehicle. |
Fault Time Condition |
---|
Immediately after fault detection. |
Service Plan |
---|
Check lines and aerial connector. Check whether the spacer is installed.If the lines and connectors are OK, exchange the aerial.If no more (new aerial) faults can be detected, replace the control unit |
Fault Impact |
---|
Partial restriction or malfunction of the convenience functions. |
Warnings | |
---|---|
Warning Lights |
None |
Control Center Messages |
Service Notes |
---|
|