| Fault Code Description |
|---|
|
The diagnosis monitors the standby current. The fault is detected when the standby current exceeds the threshold value of 80 mA. Possible fault cause: An additional retrofitted electrical consumer (e.g. hands-free system, navigation device, device for enabling the TV function when the vehicle is in motion, cool box, rodent repelling device, etc.) is connected to terminal 30, terminal 30F or directly to the battery.A component or a control unit is consuming too much current during the rest state (corroded connector, short circuit or internal fault). |
| Fault Code Conditions | |
|---|---|
| General Conditions |
Supply voltage between 9 V and 16 V |
| Terminal Condition |
|
| Driving Conditions |
|
| Fault Time Condition |
|---|
|
The fault is entered when the discharge caused by high standby current is greater than 1 Ah. |
| Service Plan |
|---|
|
Carry out following test module (ABL): Energy diagnosis.Perform an external standby current measurement by means of the clip-on current measurement probe and oscilloscope. |
| Fault Impact |
|---|
|
Breakdown possible. |
| Warnings | |
|---|---|
| Warning Lights |
Check Control message (220): Increased battery discharge. |
| Control Center Messages | |
| Service Notes |
|---|
|
|