Fault Code Description |
---|
Fault Code Conditions |
---|
Fault Time Condition |
---|
Valvetronic, eccentric shaft sensor: guide |
Service Plan |
---|
VVL-Guiding Sensor Parity Error (Bank 1) |
Fault Impact |
---|
Electrical system voltage terminal 87 >10.0 V Terminal 15 ON VVT lead sensor monitor No faults related to the sensor's voltage supply should be present (fault code 10800) |
Warnings |
---|
Service Notes |
---|
If fault codes (#10801) and (#10802) are simultaneously stored in the fault memory, proceed to check the following: 1. Dual fault is stored when VVT sensor is not connected to the DME. Is VVT sensor connected to the wiring harness? If not: Plug in and check wiring harness between DME and VVT sensor. Determine whether the VVT sensor wire shield is grounded at the DME (PIN 7-10) and sensor (PIN 4). 2. Replace VVT sensor. If only fault code (#10801) is entered: 1. Check signal wire (VVT sensor PIN 1, PIN 3) between VVT sensor and DME for breakage or short circuits and corroded plugs. 2. Determine whether a cycle signal is visible every 1 ms at sensor Pin 1. (Ignition on!). If yes, proceed to Item 3. If no, this signal wire is defective. 3. Determine whether a digital message is being transmitted through DME PIN 7-07 every 1 ms. If yes, proceed to Item 4. If no, this signal wire is defective. 4. Replace VVT sensor. |