| Fault Code Description |
|---|
|
This fault is detected if the control current is less than 0.1 A. |
| Fault Code Conditions | |
|---|---|
| General Conditions |
Terminal 30 between 9 V and 18 V Terminal 15 ON Terminal 30 ON |
| Terminal Condition |
|
| Driving Conditions |
Diagnostic mode must not be active on the vehicle. |
| Fault Time Condition |
|---|
|
Debounce for fault entry: 4 s |
| Service Plan |
|---|
|
Possible fault causes: Wiring harnessEKPS electronic fuel pump control module Perform troubleshooting according to testing procedure (ABL). |
| Fault Impact |
|---|
|
This fault code entry triggers shut-down of the electric fuel pump until the next time the ignition is switched off and on again. If the fault 'No pump RPM signal' is also registered. |
| Warnings | |
|---|---|
| Warning Lights |
Check control message: Electric fuel pump fault! Drive moderately |
| Control Center Messages | |
| Service Notes |
|---|
|
The nominal delivery volume and the nominal RPM of the EKPS electronic fuel pump control module must be greater than 0. |